New rads, towel rails and full set upgrades fitted neatly across Staffordshire
If a radiator is cold at the top, slow to warm up, or 20 years old and looking tired, swapping it usually makes a noticeable difference to how a room feels. We install single radiators, full sets, towel rails, and designer panels across Stoke-on-Trent, Stafford, Crewe, and the surrounding villages. New radiators run a lot hotter than old, scaled-up ones, the change in heat output is genuinely impressive.
Most jobs are like-for-like swaps and take an hour or two. We drain the relevant zone, remove the old radiator carefully so we don't drag dirty water through your carpet, fit the new one, refill, bleed, and balance the system. Where pipework needs re-routing, boxing it in behind a stud wall, for example, we handle that too.
Pricing typically sits between £200 and £500 per radiator depending on the size, the rad you choose, and how much pipework needs to change. Bigger projects with multiple radiators get a single combined quote so you know the full cost up front. We can recommend rads if you're not sure, and explain the difference between the budget and the premium ranges.
Once installed, the system is properly balanced, meaning every radiator hits temperature at roughly the same rate, so no room is left cold while another cooks. We tidy up, take the old radiators away, and leave the heating noticeably better than we found it.
Sean Woodward
After calling Joe to book a service he mentioned a strip down service and how vital they are to a boiler’s longevity. We went ahead and now our boiler is spotless inside and out. Joe even sent us some pictures of what he’d cleaned so we could see the work he’d carried out.Thanks for being thorough and professional highly recommend!
Chloe Hampton
Great service from Joe at JME Heating Solutions! Professional, reliable, and really knowledgeable. Boiler fitting and service were done to a high standard and everything was left clean and tidy. Would definitely recommend and will be using again.
Alfie Sturge
I realised that I had no hot water. A friend recommended Joe saying he was a trust worthy and never cuts corners. I rang him and within a couple hours he was able to come out and fixed the problem. Joe was able to diagnose a faulty diverter valve and fitted a new one. Thankfully because of Joe I had hot water.
Ross Hughes
Thanks JME heating solutions for fixing our faulty spark generator. The fault was diagnosed and repaired on the same day. Thanks for the efficient service highly recommend.We were really impressed with the service Joe provided. He carried out a full strip-down on our 12-year-old boiler, which was far more thorough than anything we’d experienced before. Previous services barely lasted 20 minutes, but Joe took the time to do everything properly and explain why a deeper service is so important every 4–5 years. It was clear he genuinely cares about doing a quality job. Thanks again, Joe!
Margaret
Joe was very reliable at coming quickly to do the work . An excellent trustworthy plumber and we would not hesitate to have him again .
Jasmine Edwards
Joe did a fantastic job at giving our 12 year old boiler a full strip service. Our old engineer never took longer than 20 minutes to service our boiler. Joe showed us why this was not the correct way to maintain your boiler and why you should have a strip service once every 4-5 years minimum. Thanks for your service Joe
We cover Stoke-on-Trent, Newcastle-under-Lyme, Stafford, Crewe, and the surrounding villages, Stone, Kidsgrove, Sandbach, Cheadle, and similar postcodes. If you're not sure whether your address is within range, give us a call on 07756 518118 and we'll let you know straight away.
JME Heating Solutions is run by Joseph Edwards, who has ten years of hands-on experience in the heating industry. The business is owner-led, so every job you book is carried out personally, no subcontractors, no rotating engineers, just consistent workmanship from the same person.
Yes. We're Gas Safe registered, which is the legal requirement for any work on natural gas appliances in the UK. The engineer carries a Gas Safe ID card and you're welcome to ask to see it. Every installation, service, and repair we carry out is signed off against the national safety standard.
Standard hours are Monday to Sunday, 08:00 to 20:00. We work weekends as well as weekdays, handy for jobs that need to fit around shift work or busy households. For urgent breakdowns outside these hours, give us a call and we'll see what we can do.
Yes, every installation quote is free and no-obligation. For boiler swaps and larger radiator jobs, we come out, look at the system, and give you a written price covering everything, parts, labour, removal of the old kit, the lot. No hidden extras when the invoice arrives.
We accept bank transfer, debit and credit cards, and cash. Payment is usually due on completion of the work. For larger installation jobs we can talk through staged payments if it helps you spread the cost, just ask when you book.
Most boiler swaps are completed in a single day, as long as everything goes to plan. A like-for-like combi swap is usually finished by mid-afternoon, while a more involved job, relocating the boiler, fitting new pipework, upgrading controls, may stretch into the next day. We give you a clear timeline as part of the quote.
There's always a bit of dust and a lot of tools about during a boiler swap, but your home will be properly protected, dust sheets down, carpet protector laid, work area kept tidy. When we're finished, the home is left in the same condition it was in before we started. Cleaning up is part of the job, not an afterthought.
Most domestic boiler installations land between £2,500 and £4,000 fitted. The exact figure depends on the boiler you choose, the size of the system, and whether any extra pipework, controls, or system upgrades are needed. We give you a fixed written quote up front so you know the full cost before any work starts.
We install all the major brands, Worcester Bosch, Vaillant, Baxi, Ideal, Glowworm, and others. For longer warranty cover at sensible money, Worcester and Vaillant are usually our go-tos. We'll talk through the options based on your home, your budget, and how long you want the warranty to last.
Yes. Removing the old boiler, disconnecting it safely, and disposing of it responsibly is included as part of every installation. You don't need to arrange anything separately, it's all part of the quote.
Every new boiler we fit comes with a manufacturer-backed warranty, typically between 5 and 12 years depending on the brand and model. We register the warranty on your behalf and hand over the paperwork at the end of the install, so the cover is in place from day one.
You should have your boiler serviced once per year to maintain the boiler's safe operation and to keep the warranty valid. Annual servicing also keeps the boiler running efficiently, a poorly maintained boiler quietly wastes gas and money long before it breaks down.
A standard annual boiler service is between £65 and £350 depending on the boiler make and model, the access, and what extra work is required. Most domestic combi services land at the lower end of the range. We confirm the exact price when you book.
We inspect the burner, heat exchanger, gas pressures, flue, ventilation, and safety controls. The case comes off, components are cleaned where needed, and we run a combustion analysis to verify the boiler is firing safely and efficiently. You get a written report covering everything that was checked.
Autumn, September or October, is the popular slot. You go into winter knowing the heating is safe, efficient, and warranty-protected. That said, any time of year is fine; the boiler doesn't mind when the service happens, as long as it happens once every twelve months.
Yes. Almost every modern boiler warranty requires an annual service by a Gas Safe registered engineer to remain valid. We log the service details, issue the certificate, and update your warranty record on your behalf. If you ever need to claim, the paperwork is ready.
We're honest about what we find. If something is wearing out or genuinely needs attention, we explain the issue, give you a fair price for the repair, and let you decide whether to go ahead. We don't push unnecessary work, small problems flagged now save bigger bills later.
Yes, most of the time people notice a real difference. A new radiator runs significantly hotter than an old, scaled-up one because the internal flow is unrestricted and the heat-output rating is what the manufacturer says it is. It's one of the most cost-effective ways to make a cold room feel warm.
Most radiator installations are between £200 and £500 per radiator depending on the size, the model you pick, and any pipework changes. Like-for-like swaps sit at the lower end; designer panels, towel rails, and rad swaps with pipework reroutes are towards the higher end.
Yes. We fit standard convector panels, low-profile designer radiators, vertical column rads, and heated towel rails. We can recommend a model if you're not sure, output, dimensions, and whether the heat will actually be enough for the room are the three things that matter most.
A single like-for-like radiator swap is usually finished in one to two hours. We drain the relevant section of the system, swap the radiator, refill, bleed the air out, and balance the system so every radiator heats up evenly. Multi-radiator jobs take longer but follow the same process.
No more than absolutely necessary. We drain the system carefully, catch any drips, and lay down protection where we're working. Old radiators get taken away with us so you don't need to deal with disposal. The room is left tidy and the heating noticeably warmer.
Yes. System balancing is part of every radiator job. We adjust the lockshield valves so the flow is even across the whole system, meaning every radiator hits temperature at roughly the same rate, no room is cold while another cooks, and the boiler doesn't have to overwork to heat the property.